This article explain how to stop superfetch cmd. Superfetch is functionality in windows ten presented for two purposes. The first one is reducing boot time, and the second one is filling apps faster. Superfetch does this by preloading them in memory. It likewise tracks your use pattern for a better preloading decision. For examples, if you open chrome in the early morning.
How To Stop Superfetch Cmd In 2023
In this article, you can know about how to stop superfetch cmd here are the details below;
It will preload chrome in the early morning hours so that the app loads much faster. But sometimes prefetch becomes major causes of high disk use. Here in this short post, we will explain how to disable superfetch in windows 10. Also check wireshark no interfaces found
Note: In the new Windows 10 Update, Windows OS has actually renamed it as SysMain. To disable this service through the Registry Editor, do the following.
Disable Superfetch/ SysMain through the Service manager
1. Search Services in the Taskbar Search
2. Now, Choose Services.
3. Find Sysmain.
4. Double click Sysmain.
5. Now, Choose Startup Type to Disabled from the dropdown.
6. Click on Stop to stop the service.
7. Choose Apply.
Disable superfetch/ Sysmain through command prompt
Step 1– Open command timely as admin.
Step 2– Write the command code given listed below and strike get in.
sc stop “SysMain” & sc config “SysMain” start= disabled.
Note:– To allow it again, just run the command offered below.
sc config “SysMain” start= auto & sc start “SysMain”.
Disable superfetch through windows registry.
Step 1– Press Windows key + R together to raise the run command box.
Step 2– Write Regedit in the Run command box and hit get in.
Step 3– Now browse to the place offered listed below.
- – HKEY_LOCAL_MACHINE.
- – SYSTEM.
- – CurrentControlSet.
- – Control.
- – Session Manager.
- – MemoryManagement.
- – PrefetchParameters.
Step 4– On the ideal side of the appeared box, discover EnableSuperfetch entry from the list.
Put one of the following worths in EnableSuperfetch depending upon your requirement.
0– to disable Superfetch totally.
1– to allow prefetching when the program is launched.
2– to enable boot prefetching.
3– to enable prefetching of whatever.
If this entry is missing, just do a right-click on the PrefetchParameters folder, then choose New > DWORD Value. Name this EnableSuperfetch and do the actions given above.
You can also check over other articles like:
